How to Drain a Toilet Bowl When the Flush Is Broken

Answer

The components and handles for the toilet tank are not too costly and are not difficult to install. Before attempting any type of repair on your toilet, you will first need to empty all of the water out of it, regardless of whether it is leaking, has a broken handle, a broken toilet flapper chain, or another kind of issue. It is required to drain the tank in order to check it and eliminate the possibility of a flood.

Draining a Toilet

According to Bob Vila, removing water from a toilet’s tank and bowl is a simple process that is also likely one of the least dirty do-it-yourself projects involving toilets. You most likely already own the necessary equipment, which consists of a big sponge, a pitcher, and a bucket with a capacity of five gallons. Place some used towels around the base of the toilet, then remove the cover from the toilet seat and the seat itself. Locate the metal cutoff valve on the wall behind the toilet, which should be around the base of your tank. This will allow you to turn off the water supply. To make this more snug, turn this knob in the clockwise direction.

While protecting your hands with rubber gloves, remove the lid from the toilet tank, and then carefully set it down on a flat, soft surface, such as an old rug. It is necessary to flush your toilet while maintaining pressure on the handle until the water in the tank is completely removed; there should be no more than a half an inch remaining. If the handle is broken, you will need to find an other means to empty the container. If there is still an excessive amount of water, soak up the excess with a big cleaning sponge and then pour the liquid into the bowl of the toilet while you continue to work.

Draining a Toilet if the Toilet Flapper Chain Is Broken

Even if the chain connecting the handle to the flapper is broken, you may still empty your toilet by pushing up on the rubber flapper that is located in the tank. You just need to take a few simple steps to do this, and there is no need to turn off the water valve. Mr. Rooter demonstrates how to do it. Take the cover off the tank, and search around for a chain. If the chain has been dislodged from the inside handle arm, just slip it back onto the arm, and then give the handle another go. Whether it does not work, check to see if the chain is attached to the flapper; if it is, there is a chance that you can reattach it.

After you have finished emptying the bowl, grab the bucket and pour around three gallons worth of cold water into it. Either fill it up in your bathtub or use a pitcher to fill it up from the tap in your sink. Both options are available. You should swiftly pour the contents of the bucket into the bowl while holding it a few inches above it and elevating it as you pour to increase the rate of flow. After you have used the huge sponge to remove any residual water from the bowl, you may go on to the next step in the repair process.

Replacement of Toilet Tank Parts

There is also the possibility that the flapper is the cause of the issue. It need to be positioned so that it is resting above the aperture that can be found at the base of the inside of the toilet tank. If it seems to be out of place, you should try moving it to a different location. If it seems to be in the correct area, but the seal isn’t quite perfect, you may be dealing with a different sort of issue.

The pieces of the toilet tank that wear out over time are the handles and the flappers. If any of these seem to be damaged, you may locate the model of your toilet by looking it up online or at a local hardware shop, and then purchase new toilet handles and other toilet tank components to fix the problem. Even if there are not many moving parts in a toilet, if you are unable to repair it in a short period of time or if you begin to have a water problem that appears to become worse very rapidly, the best answer could be to contact a plumber.

Bucket

Pitcher

Large sponge

Towels

Rubber gloves