How to Install Laminate Flooring on an Uneven Surface

Answer

When installing laminate flooring, the subfloor surface must be absolutely level in order for the floor to be level. If this does not occur, the floor will eventually conform to the contour of the surface. Before you install the flooring, you may make the floor even by using compounds that are accessible to you. When poured over the subfloor, these self-leveling substances smooth out surfaces that are not perfectly flat. After they have dried, the surface will be completely level, and it will be ready for the installation of the laminate flooring. The installation of laminate flooring is a task that the typical do-it-yourselfer should have no trouble doing on their own.

  1. In order for the laminate flooring to get acclimated to the temperature of the space, the boxes must be opened and the planks must be laid flat in an adjacent room. Take up any flooring that is already there. Dust and other types of debris may be removed from the bare floor by using a vacuum cleaner. Before applying levelling chemicals, the floor has to be well cleaned.

  2. In order to locate low points in the floor, lay a carpenter’s level out on the surface of the floor beginning at one end and working your way to the other. First, pour levelling compound into the low spots, and then, using a broad putty knife, scrape out any extra levelling compound. Before moving on to the following phase, you must wait twenty-four hours for the levelling compound to become fully cured.

  3. Sand any high places that you see using the sandpaper to get the levelling compound as smooth as possible. Check the floor with the carpenter’s level once more to make certain that it is level and prepared for the installation of the laminate flooring.

  4. Installing the laminate floors requires you to start in one corner and work your way across the room in the same direction as the longest straight wall. Install the first row of flooring along the whole of the wall from one end to the other. While you are laying down each board, use a scrap piece of wood and a hammer to tap it on the board that came before it. It is important to refrain from tapping directly on the floor planks themselves to avoid damaging them.

  5. Hammer finishing nails into the flooring at the tongue to secure the first row, and then use a nail gun to secure the remaining rows. The section of the board that slides into the groove of the next board is called the tongue of the board.

  6. The second row of boards should be installed in exactly the same way as the first row of planks. However, make sure that the ends of the boards are staggered in such a way that they do not touch with the ends of the first row. Continue working your way around the room until you have laid the laminate flooring everywhere.

    Things You Will Need

    • Vacuum cleaner

    • Carpenter’s level

    • Self-leveling compound

    • Wide putty knife

    • Sandpaper

    • Claw hammer

    • Finishing nails